Spring distance ring/spacer/trim packer/lifting ring TREKFINDER for SUZUKI Jimny I & II
+ 10 millimeters in red - for lifting the front and/or rear axle
Suitable for all Jimny models, front and rear axle
Jimny II Type GJ & HJ from MY 2018
Jimny I type FJ to MY 2018
for the front axle spring
for the rear axle spring
+ 10 millimeters lift
INSTALLATION NOTE: fit the ring between the upper end of the spring and the spring plate.
Ensure that the brake line length is sufficient.
Ensure that the shock absorber length is sufficient.
Check the headlight setting.
Ensure the coupling ball is at the correct height.
If you have a load-dependent headlight regulation, e.g. an LED light, then you need to check it and if necessary adjust/change or extend it.
You may have to measure or recalibrate the sensors of the driver assistance system, please double check this. This has to be done according to the specifications of the vehicle manufacturer.
In vehicles with a load-dependent brake pressure regulator, this must be reset to the empty level (according to the vehicle manufacturer's specifications).
After the conversion, the vehicle's axle geometry must be measured and, if necessary, corrected according to the vehicle manufacturer's specifications.