Spring spacer ring red +10 mm TREKFINDER for SUZUKI Jimny I & II

INSTALLATION NOTE: fit the ring between the upper end of the spring and the spring plate.
Ensure that the brake line length is sufficient.
Ensure that the shock absorber length is sufficient.
Check the headlight setting.
Ensure the coupling ball is at the correct height.
If you have a load-dependent headlight regulation, e.g. an LED light, then you need to check it and if necessary adjust/change or extend it.
You may have to measure or recalibrate the sensors of the driver assistance system, please double check this. This has to be done according to the specifications of the vehicle manufacturer.
In vehicles with a load-dependent brake pressure regulator, this must be reset to the empty level (according to the vehicle manufacturer's specifications).
After the conversion, the vehicle's axle geometry must be measured and, if necessary, corrected according to the vehicle manufacturer's specifications.